Migration Advice Needed

[Ozzboss]

Hi guys,
I am trying to run the Migration Manager to transfer sites to a newer server. When it runs through the checks I am getting the folowing messages:

The following Apache modules are not installed on the destination server: security2,sed,evasive20. Please install and enable these modules to prevent possible problems.
The following Apache modules are disabled on the destination server: unique_id. Please enable these modules to prevent possible problems.
The component Domain Keys is turned off on the destination server. Please turn on Domain Keys on the destination server. 9 domain(s) will be affected. Mail server settings
The component Maillist Service is not configured on the destination server. Please configure Maillist Service on the Tools 1 domain(s) will be affected. Change settings
The atmail webmail service is not available on the destination server. Instead, Panel will use the following webmail service: horde. To use the same webmail as on the source server, you should install it on the destination server. 4 domain(s) will be affected. Install the component

Are these modules that I should have installed? or is it better without them?
Your advice would be appreciated as im running out of time before my old server is cancelled.

Old server is running CentOs5.10 with plesk upgraded to 11.5.3 and new server is fresh install of CentOs6.5 and plesk 11.5.3

Cheers
Paul

 

[IgorG]

Just go to Tools & Settings>Apache Web Server Settings on destination server and check status of mentioned modules at least. Modules security2,sed,evasive20 are not installed by default on Plesk server. Looks like they are custom modules. Make sure that they are in use and install them on destination server if necessary.

 

[Ozzboss]

Thanks IgorG. I enabled unique-id but the rest of them are not listed.
I am thinking they might have been part of ASL which I won't be adding to the new server.
Are they likely to cause issues with the migration or can I ignore them?

 

[IgorG]

Maybe you can disable these modules on source server before migration? Is it possible?

 

[tizianob]

Hello,
we have the same problem . uniqe_id the form and active but inside the plesk rirsco not see it.
How you can solve?